Circuit Breaker Repair

Why Does My Breaker Keep Tripping?

There are three common reasons. The first is too many things on one circuit, like a space heater and a hair dryer in the same room.

The second is a short circuit, where a hot wire touches another wire. The third is a ground fault, often caused by water or a damaged cord.

Sometimes the breaker itself is worn out. Old breakers can get weak and trip with very little load.

Signs You Need an Electrician

• The breaker trips right after you reset it.
• The breaker will not stay on at all.
• You see scorch marks or smell burning near the panel.
• The breaker handle feels loose or hot.
• Lights dim when a big appliance turns on.

How the Repair Works

The electrician tests the circuit to see how much power it carries. They check the outlets and devices on that circuit for damage.

If the breaker is bad, they replace it with the right type and size. If the circuit is overloaded, they may add a new circuit to split the load.

You get a free estimate before any work starts.

Safe Steps You Can Take

Unplug a few things on the circuit, then reset the breaker once. If it trips again, leave it off and call an electrician.

Do not tape a breaker on or replace it with a bigger one. That removes the safety it gives you.

How to Book Circuit Breaker Repair

Call 844-521-2392 any time. Tell us what you need, the address, and when you are free. We book an independent local electrician who serves your area. They give you a free estimate before starting, and you decide if you want to go ahead.

We book this service in Baltimore City and in Baltimore, Anne Arundel, Howard, Harford, and Carroll counties. See our service areas for towns.