Electrical Safety Inspections
Buying, selling, or renting out a home? Get a full electrical safety check and fix any code problems found.
Learn about Electrical Safety InspectionsWhen they are linked together, one alarm sounding sets off every alarm in the home. That gives everyone more time to get out.
Where Smoke Alarms Should Go
- Inside every bedroom
- Outside each sleeping area, like the hallway
- On every level of the home, including the basement
- Near, but not inside, the kitchen to cut false alarms
Hardwired vs Battery Alarms
Battery only alarms work, but they fail when the battery dies. Hardwired alarms use house power, so they keep working.
Maryland has smoke alarm rules for homes. In many cases, battery alarms must have sealed, long life batteries. A hardwired system with battery backup is a strong choice.
Adding Carbon Monoxide Alarms
If your home has gas heat, a gas stove, a fireplace, or an attached garage, you also need carbon monoxide alarms.
Combination smoke and carbon monoxide alarms can be wired in the same way. The electrician can add them at the same visit.
How Installation Works
The electrician runs a wire between alarm locations, often through the attic or basement. They connect the alarms so they can signal each other.
They test every alarm before they leave. Smoke alarms should be replaced every 10 years.
How to Book Smoke Detector Wiring
Call 844-521-2392 any time. Tell us what you need, the address, and when you are free. We book an independent local electrician who serves your area. They give you a free estimate before starting, and you decide if you want to go ahead.
We book this service in Baltimore City and in Baltimore, Anne Arundel, Howard, Harford, and Carroll counties. See our service areas for towns.
Smoke Detector Wiring Questions
Can wireless alarms be linked too?
Yes. Some alarms link by radio signal. These can be a good fit where running wires is hard.
Why does my alarm chirp?
It usually means the backup battery is low or the alarm is too old. Check the date on the back.
Do I need a permit?
New hardwired alarms may need one. The electrician will tell you.
